Item Description

Bought this a while back but never really got on with it as I fancied my own 3d printed kits a bit too much.

Handguard is just a thing i got in a trade, not the same manufacturer. You can use any M4 handguard with the right barrel nut.

Comes with rail stock adapter as well as the original one for a buffer tube.

The factory stock image shows everything I will be including.

Everything is present plus a couple of extra smaller screws just to be safe. However a couple of the screws have been stripped with a ghetto dremel solution as they were originally in too tight. They look ugly and have left some scratches and gouges around the screwholes on the carbine kit but is just some ugly cosmetic blemishes.

You can replace the screws easily with a countersunk hex socket M4 size screw. you can easily measure the length yourself.

Otherwise its good to go, just dont threadlock or over tighten those ones else you have to get the dremel out again.

The handguard also had a similar treatment where previous owner over tightened one and it stripped trying to get it out. You can replace if you want but it tightens fine with 2 out of 3 screws.

NOTE: No instructions included but assembly is straight forward, happy to talk thru it if needed.

ALSO NOTE: 2 screws are scuffed but functional as
stated.

ALSO NOTE: No AAP pistol, stock, or M4 outer barrel is included. You will need your own.